this post was submitted on 03 Jul 2023
5 points (100.0% liked)

Ask Electronics

3757 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
5
Can I switch this constant current LED driver at 38kHz? (discuss.tchncs.de)
submitted 2 years ago by silvio2402@discuss.tchncs.de to c/askelectronics@discuss.tchncs.de
9 comments fedilink hide all child comments
 

My goal is to drive an infrared LED like (this SFH 4727AS) to control IR remote controlled devices (for example a TV).

I can already output the signal on a pin of my microcontroller. The signal has a carrier frequency of 38kHz.

I am however limited to a 5V 1A power supply and would like to drive the LED as close to the 5W psu limit as possible.

I first thought about using a MOSFET like this AO3400A together with a resistor, but decided it was worth using an LED driver, do you agree?

Now I'm looking at this PAM2804 constant current LED driver but I'm not sure if I can just supply my signal to the EN pin. The EN pin is meant for PWM-dimming, so does that mean the output is smoothed to prevent flickering?

I'd love to hear your thoughts about how I should go about this. Thanks

you are viewing a single comment's thread
view the rest of the comments
[–] cmnybo@discuss.tchncs.de 1 points 2 years ago

Those calculations are correct.

Since the remote control signals are short and low duty cycle, you could use a capacitor to provide the peak current for the LED without going over the maximum current of the power supply.