Hi, my 3d printer psu fan gave up the ghost, and I wanted to replace it. It was pretty noisy, so I thought about upgrading from a 30mm to an 80mm fan. I am designing the top case with mounting holes, and want some input on where to place the new fan. The original placement is the box with the red color. The green and blue box are some options I thought of for the new fan placement. Would placing it over the busier part of the pcb yield lower temps, or is that a bad idea? Does placement even matter for psu fans?
The new fan has higher airflow, but lower static pressure than the original one, and the plan is for it to always spin at a low rpm and occasionally speed up when the psu detects a high temperature.
The original config runs it completely fanless until the psu reaches 50c and only then does it send voltage to the fan header.
this post was submitted on 06 Oct 2024
6 points (87.5% liked)
Ask Electronics
3324 readers
1 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Are you 3D printing a new top plate for the psu? Remember that the steel housing also functions to contain the emi generated from the psu components. You could end up increasing electrical noise for other components if your new top plate isn't conductive and grounded.
I didn't think of that. Thanks for pointing that out! I guess I can cover the inside in aluminium foil tape to stop the electrical noise