this post was submitted on 04 Oct 2023
5 points (85.7% liked)

Ask Electronics

3261 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
5
Housing for resistor? (lemmy.world)
submitted 11 months ago by thisisawayoflife@lemmy.world to c/askelectronics@discuss.tchncs.de
8 comments fedilink hide all child comments
 

I have some metal film 1/2w 2.2ohm resistors in some car wiring. I'm concerned about the durability of this install and am seeking advice on how to protect the resistor once it's soldered in place. The obvious is heat shrink tubing, but it's there anything more substantial?

I'll be using these resistors in a custom pigtail that will plug into the car wiring. 3D printed housing? I have tried searching and I haven't found anything like that.

you are viewing a single comment's thread
view the rest of the comments
[–] Number1SummerJam@lemmy.world 1 points 11 months ago

Look for a higher quality resistor? There will definitely be something in your range that is made for durability.