I believe this was caused by the horrendous layer adhesion of this silk PLA. Didn't have time to tune the filament, and based it off of another silk one.
this post was submitted on 30 Apr 2025
127 points (97.0% liked)
3DPrinting
17882 readers
82 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
@anguo Actually it seems like your bed slipped halfway (see the sudden misalignment on Y axis clearly visible on the bowl) and even though printer kept printing well afterwards, it propably reached some point where it started printing "into the air"
Everything that was supposed to be attached at the bottom of the bowl, wasn't. There were three poles and some sort of tower, all with small footprints. All the supports weren't attached either. I also could easily separate the layers with minimal force.
I think you're right that a bed slip caused a chain reaction, but the layer adhesion certainly didn't help.
@anguo
I consider this information important as this mean it's not sticking for some (not hot enough or not enough material?) reason.
I only had splittable (not that easily though) layers with ABS/ASA, never with PLA or PETG
I just retightened the belt and lubricated the rods a week or two ago, after another failure, not sure what could have caused the slip