Hi,
I have built a microvawe transformer spotwelder, I have put a single turn of welder wire for in the secondary and I'm timing it with arduino. Worth mentioning it was/is a 230V transformer. Electrodes are sharpened copper rods. I believe the voltage is still high. The spotwelds it produces are slightly discolored and not as strong as you would expect. Is this design fundamentally borked? Is there anything else I can make to make it better?
Photo from test stage before it was built into a project box, it is less "shocking" now.
this post was submitted on 18 Oct 2023
10 points (85.7% liked)
Ask Electronics
3259 readers
1 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I have 230V or 400V three phase. I live in the EU. So this cannot be solved without replacing the winding on the transformer I guess.
If it's just a matter of getting a larger voltage, then you already got 400V. No need for new windings, unless the insulation on the primary can't handle 400V.
I need lower voltage. 1-2V on the secondary. I have 3V rms now.
If you have a 230V supply and a 230V transformer, you are fine. I believe they thought you were using a 120V supply on a 230V transformer.
Raising the input voltage will probably not get you what you want.