Hobbyist/DIY guy in a garage. I use Linux. I have briefly tested Eagle and a couple circuit design apps but didn't like anything about any of them, did not spend sufficient time with them either, though. Eagle is going away? Any recommended apps for designing pcb and/or services? I am also open to more artisinal methods. What direction should I point my momentum? Not afraid to try things out but also not wanting to waste time. I have been breadboarding for a minute, learned to solder, benn making some pcb gadgets and think I am ready. Thank you. (Pic is audio mixer with two NE5532 and LM386)
Have a look at EasyEDA. Browser UI, schematic and PCB design, linked to JLCPCB for ridiculously easy board creation, and if you take care to use components they have in stock out of their design libraries you can also do fully populated boards ready to go.
Here's a post I made about a solar hot water system controller using easyEDA with a few images of the board and schematic at the bottom.
I will check this out, thank you for sharing.