3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
So… if it’s something that’s going to set on a shelf or something like a wh figurine, you don’t need to prime with acrylic or enamel.
If it’s something that’s going the handled (like say, a cosplay prop,) your mileage will vary.
I’d recommend printing off small test parts to see how the paint cures and such. I use small shot-glass-size vase mode prints. (Any one the vases will work, but I suggest anything with more complex contours and a few hard edges.)
Then they get double use as a glue pot when I’m doing glueups with barges cement or similar adhesives (and painting too.)
If you find you do need primer… the stuff I’ve found to work best is rustoleum filler-primer. (Yes. The spray can.) you’ll lose surface details, since it’s designed to fill that in, but makes a wonderful foundation.
Also scuff the surface with a coarse sand paper before you do anything else. This will give whatever base layer you’re using a bit more to bite into.