The only tell is a slight bump on the seam line of the back. It’s 0.1mm layer heights and 0.6mm thick.
Printed in TPU, I was looking for a solution like this for a future project and wanted to share it with someone.
this post was submitted on 22 Apr 2026
52 points (98.1% liked)
3DPrinting
22934 readers
40 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
CAD, got the parts designed up, then made 2 prints.
Print 1 is one half while print 2 I only printed the first layer. Aligned the 2 prints, then resumed printing.
I used magnets to hold the finished part down as to not move.
Were you able to remove it from the bed and re-align it? That's some clean alignment.
Look closely in the middle and you will see a nook. That said the clear TPU is helping hide it