overview for i_like

4

Print fails with "frayed" ends (feddit.org)

submitted 1 month ago* (last edited 1 month ago) by i_like_water@feddit.org to c/3dprinting@lemmy.world

4 comments fedilink

Hi, I've tried to print a model plane for my father. It's this model, using this LW-PLA right after purchase.

As you can see in the image of this post, the print is going well until it reaches a certain layer, where the filament does not get deposited properly for the entire layer, only intermittently. The following layers then, of course, have the same problem and I get this failed print with these "frayed ends". Additional attempts failed the same way at a similar layer count.

If someone has some experience with lightweight PLA (LW-PLA) and knows what can be done to solve this, I and my father would greatly appreciate the help.

Thanks in advance.

Edit: Additional info: I'm using the PrusaSlicer files from the linked page. Edit2: The printer is Prusa Mk4.

Gamepad not recognized when turned on after starting games in c/linux_gaming@lemmy.world

[–] i_like_water@feddit.org 8 points 2 months ago

I think the issue is how the games are programmed. Some games check which controllers are plugged in only at start and some do regular checks during runtime.

Local AI is one step closer through Mistral-NeMo 12B in c/technology@lemmy.world

[–] i_like_water@feddit.org 35 points 3 months ago (1 children)

From the top of my head: the context size is way higher. 128k tokens vs 8k usually.

Linux 6.10 released in c/linux@lemmy.ml

[–] i_like_water@feddit.org 12 points 4 months ago* (last edited 4 months ago) (1 children)

You're not alone in that. I remember when Blender 2.80 was about to release and it was a big milestone and everybody online was hyping about "Blender 2.8". I think even Blender themselves went with the flow and changed the marketing.