VoIP

1 readers

1 users here now

Rules

Be civil. Disagreements of varying intensities will happen, but particularly vitriolic attacks will be pruned from the discussion.
Do not promote or advertise for any business, service or product unless responding to a specific request for recommendations. This includes recommending a user change providers when they have not indicated they are interested in doing so.
Do not send private messages to users, or invite users to send you a private message, for the purpose of promoting or advertising a business, service or product.
Do not invite, encourage, or seek help with engaging in unethical or fraudulent activity relating to VoIP, such as call spoofing, robocalling and autodialers, or fraudulent STIR/SHAKEN attestation.

founded 11 months ago

MODERATORS

communick@netheads.online

Configuring an SBC for SIP trunk with pilot user. (alien.top)

submitted 9 months ago by geaclaesson@alien.top to c/voip@netheads.online

1 comments fedilink hide all child comments

It's been set up for using certificate before, and now we're going to a new vendor that uses pilot user and I don't known where to put the authorization information since there's pass through / remote and local tables.

you are viewing a single comment's thread
view the rest of the comments

[–] tgoblish@alien.top 1 points 9 months ago

I don't know anything about Ribbon SBCs, but there should be somewhere to create and configure a trunk that is most likely internet based, and you will need to whitelist the telco vendor ip's etc. , then create the trunk which you will have options for digest authentication or even registration of an ip based trunk. Then you will create dial plan and use GHM (potentially) , to route your signaling/media.