this post was submitted on 06 Jun 2025
21 points (95.7% liked)

3DPrinting

18378 readers
192 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
 

So I finally got an opurtunity to get a 3D printer, and i want to buy a Voron. I found a V2.4 with 350mm build volume for 770€. Is it worth it? How reliable is a Voron? Have any of you got any experience? All input welcome.

(Edit) I forgot to clarify, the printer is new, not second-hand.

you are viewing a single comment's thread
view the rest of the comments
[–] froh42@lemmy.world 4 points 2 days ago* (last edited 2 days ago) (1 children)

Look on github for Rappetor's SV08 mainline repository. You'll need a new mmc or sd card (both are ok) and a "five bucks" STLink programmer, but then it is quite easy to put mainline klipper on your sv08. The mainboard is a cb1 clone with the "main" ST microcontroller for driving the steppers on the same board (for cost reduction, probably)

That's the prerequisite for using a probe. like a btt eddy on a SV08, for example.

Other than the SV08 has a few issues like super noisy board fan which can be very easily be taken care of. (Funnily software control of the fan is possible, but just not done in the default firmware)

My mods are mainline klipper, btt eddy, new (printed) extruder shroud with better airflow, a microswiss hotend and a second camera (USB webcam for second viewing angle and better resolution).

Out of the box the SV08 has a bit of problems keeping a consistent Z offset due to missing temperature calibration for the probe. More reliable solutions (ported from voron) like klicky are available. I chose eddy - but haven't perfectly tuned it in, either. I'll try the eddy-ng firmware (github) next week.

[–] wjrii@lemmy.world 3 points 2 days ago

Thanks! I am going to keep those all in my back pocket for when the honeymoon of not having a $99 "box o' parts" Voxelab wears off, though I feel a little guilty for never installing that BLTouch clone now.

I haven't printed much with the Sovol yet. So far, the main things I'm running into are bed adhesion (the old standby of a washable glue stick is helping), and I've had a couple of vertically oriented parts get knocked off the bed, and slowing down quite a bit helped.