Dropped one of my wife's favorite mugs. Anyone up for a paid commission/challenge to print a new handle? Have you ever seen this work? Thanks!
this post was submitted on 05 Mar 2026
19 points (80.6% liked)
3DPrinting
21957 readers
20 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Not sure how well super glue will work, but if it specifically says ceramics on it you're probably fine. A superglue gel will be easier to work with than the normal stuff.
Shortly after it sets, use a wet paper towel to clear away some of the excess adhesive. It'll make the joint look nice and clean when it cures, and it will be very difficult to clean up after curing.
Superglue works extremely well on coffee mugs. I have one that's got the handle held back on with superglue and it's been that way for probably close to a decade at this point. The stupid 1970s ceramic tile toothbrush holder in my downstairs bathroom is also held together with superglue...
I'm not entirely certain I'd be keen to try putting back together any of the liquid holding parts of a mug with it, but if you did it carefully and very thoroughly it wouldn't surprise me if that worked as well.
Good to know! I usually jump to epoxy for anything that needs to be 'structural' (like a coffee cup handle).
As a bonus, if you apply it well, it also has some sealing ability. I fixed a bowl that broke pretty cleanly in half and it still holds soup without a problem.
Superglue works if there is no missing pieces. Its bond strength plummets when gaps become greater than a hundred micron or so