this post was submitted on 07 Aug 2023
19 points (100.0% liked)

Ask Electronics

3313 readers
5 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.


founded 1 year ago
MODERATORS
 

I purchased an e-bike which was advertised as just needing the batteries replaced. The li-ion batteries had been sitting dead for months. Once I got the battery removed it was clear that was not the case. You can see the hole where the plastic melted from this component overheating on the board. The burnt one is the same as those in the center of this photo.

What is it and how do I determine the correct replacement?

top 10 comments
sorted by: hot top controversial new old
[–] altima_neo@lemmy.zip 14 points 1 year ago* (last edited 1 year ago) (1 children)

looks like a surface mount chip resistor, 22 ohm?

[–] carzian@lemmy.ml 27 points 1 year ago (2 children)

As Altima said, it's a 22ohm SMD resistor. You'll need to measure it to get the package size.

Unfortunately resistors don't really just burn out. If the resistor did cause damage from overheating, it's because something drew too much current. My guess is there's a short somewhere else, but there's almost certainly more damage than that resistor.

Good luck!

[–] altima_neo@lemmy.zip 4 points 1 year ago

I was thinking the same. How the heck does a resistor cause that much damage? Definitely not the resistors fault alone.

[–] turddle@lemmy.world 3 points 1 year ago

This right here. It’s likely not the resistor itself even though it’s showing the most symptoms of the overall problem.

Somewhere along that circuit branch is a short or something causing too much current to be drawn through the resistor here.

[–] H3wastooshort@lemmy.blahaj.zone 9 points 1 year ago* (last edited 1 year ago)

I dont think the resistors are faulty but the design. Resistors (especially low-ish value 22Ohm ones) are meant to dissipate energy as heat. Putting them in a cramped housing made of plastic, then using them to dissipate high power is going to build up heat in there. There could also be another component faulty that puts too much current into the resistors. They are probably part of the balancing circuit.

[–] LowtierComputer@lemmy.world 8 points 1 year ago (1 children)

This is my first post here. Have I attached the photo correctly?

[–] skankhunt42@lemmy.ca 4 points 1 year ago

I can see the photo. Can't offer help though.

[–] RedBauble@lemmy.world 7 points 1 year ago

They are 22ohm resistors. You can see they are resistor by the marking R on the pcb. The first two digit is the value (22), the last is the multiplier (0), so it would be 22*10^0 =22 ohm

[–] Lemmesee@lemm.ee 4 points 1 year ago

Looks like a 22 ohm resistor

[–] dmention7@lemm.ee 3 points 1 year ago

Maybe I'm looking at the wrong thing, but I don't see melted plastic. I see a collapsed bubble (a "fisheye") in the conformal coating that is providing moisture resistance to the components.