Homelab

371 readers

3 users here now

Rules

Be Civil.
Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
No memes or potato images.
We love detailed homelab builds, especially network diagrams!
Report any posts that you feel should be brought to our attention.
Please no shitposting or blogspam.
No Referral Linking.
Keep piracy discussion off of this community

founded 1 year ago

MODERATORS

communick@selfhosted.forum

rglullis

Can't Connect to AP9361 (alien.top)

submitted 11 months ago by warden_of_moments@alien.top to c/homelab@selfhosted.forum

5 comments fedilink hide all child comments

Hello all,

I purchased a AP9631 on eBay and installed it in my SMT2200RM2U. It lit up, it pulled an IP address...but I can't connect to it. I reset it and it reconnected but no change.

I can ping it and the device IP config tool finds it. But when I try to bring it up, it doesn't connect. I've tried http/https. I tried with IE on Windows10, no dice.

I Googled with Bing and have tried some of the utilities on the APC site with no luck. I didn't find much around connecting to it. Am I missing something?

top 5 comments

sorted by: hot top controversial new old

[–] Xenkath@alien.top 1 points 11 months ago (1 children)

Have you tried to ssh into it?

[–] warden_of_moments@alien.top 1 points 11 months ago

I didn’t but I bet that will work since I can ping it. I’ll try and see if I can see what’s going on. Now to find the available commands…

[–] jabuxm3@alien.top 1 points 11 months ago (1 children)

My recommendation would be to get a serial cable for the apc management card and login to it to do a factory reset procedure. At that point you can run through the whole provisioning process and confirm that it’s all set up correctly and working as expected. I’ve had to do this with several 9631 devices over the years on smt750s and it works great thereafter. Also keep in mind that that firmware on the 9631 is separate from the firmware on the ups itself. Both may need to be updated independently from each other and shutdown entirely to be performed. Best to do it on the bench before placing them into service.

[–] warden_of_moments@alien.top 1 points 11 months ago

I’ll look at that doing that today.

[–] SilentDecode@alien.top 1 points 11 months ago

I Googled with Bing

You what now?!

Try to use the APC Firmware updater. Your firmware might be stuck and the way to go is to update the firmware. This might be a little hard to find, because APC recently did a dick-move and threw all their NMC firmware utilities behind a MASSIVE paywall. If you really can't find the tool, I can link you one. Send a DM if you're interesed. I think I have a tool for the AP/9630/AP9631, but I'll have to check to be sure.