Gumus

No no, don't do that. If FDM (classic filament printer, as you say) is a hassle for you, then SLA (a UV resin printer) is not for you at all. It's way more involved, requires protective gear as the resin is toxic while uncured, and requires a ventilated work space. Also, generally SLA is waaaay slower than FDM, due to significantly increased resolution.

They're just intended for different use cases and different requirements. In most cases they're not an equivalent substitution for each other.

Soup is just beef tea

I wear a tungsten ring, which is nigh indestructible. Once I got stung by a wasp between my fingers. I instinctively took the ring off immediately. A few seconds later my fingers swelled like crazy. I think I might've lost the finger if I didn't take the ring off in time.

for now...

You need this: https://github.com/nvbn/thefuck

Check out Hetzner, a German cloud provider. Established, reliable and way cheaper than AWS.

I know migrating is nigh impossible for most large apps, but creating a new one on AWS/GCP/Azure is so shortsighted.

More people need to know about alternatives.

You know you can remap it on Switch, right? It won't change the labels, but who's looking at the controller anyway.

I made a trip all the way to Svalbard last summer and it was amazing. I seriously considered looking for a cabin somewhere in Norway countryside and moving there may-september every year.

Where I'm at, the bed is 30°C when the printer is off right now 🥲

"Attention is all you need" came out in 2017...

You can only manipulate one particle at a time.

Everyone knows where the gold is stored.