So, I have a pair of the Sony GTK XB5 working well, it sits under my desk currently and I've noticed, listening to music from it while being under my desk isn't as good as having a clear path to reach my ears. This is obviously expected.
Now my plan is to tear it apart and make use of the current drivers and DSP and split the single unit into two. I've already tested and there are 2 Tweets and 2 Woofers. Doing a stereo test with the speakers away from each other, I can confirm the tweeters and woofers have their own channels. Hence I would like to split it into two separate units and keep it on my desk.
I’ve seen a lot of posts asking where to start with building custom speakers, and a lot of the time the answer is to use kits as building speakers with off the shelves drivers requires tuning and a lot of 'maths & science'. Is this tuning required even on a preprogrammed DSP as mine while changing the housing for the drivers? I’m looking to creating a two new speaker boxes for these drivers and suspect it will change the way it sound. Are there any auto adjusting programmes while factoring in I can’t modify the factory DSP.
Apologies if I’ve misused technical terms or got it completely wrong. I am new to this space and if I go forward with it, it’ll be my first. :)
You best bet is to invest in buying / building custom stands to hold that speaker at your desired height over your desk.
The woofers will need the same volume of space either way to play according to spec. The tweeters probably don't get low enough to hide the woofers (more likely mid-full rangers) in a separate enclosure without some serious loss of mid-range from the woofers and bad directionality. While the home theater standard is satellites (tweeters / mids) playing down to 60-120 Hz with the THX standard requiring 80 Hz or lower, nearfield PC speakers can get away with 150-200 Hz as the low knee on the satellites without upper bass being too thin due to directionality from the separate sub.
It is unlikely you can fabricate an enclosure or set of enclosures that will sound better than the carefully designed one for those drivers. Just about every boombox and portable speaker is very cheap drivers with a very specific enclosure, DSP, and target listening volume. This is why so many cheap speakers and most boomboxes and outdoor speakers sound like ass at low listening volume levels. Heck, even a lot of the cheaper Dayton stuff even sounds like crap at low-mid volume or nearfield use.
As for the DSP, even with experience with DSPs and identified components, it's unlikely many would be able to reprogram it to re-balance for a different set of enclosures. With no experience with electronics I am going to outright say it is not going to happen, especially if you are asking basic questions without enough research and knowledge to be past those questions. The DSP is programmed against the drivers, enclosure, amp, and use case requirements and limits. It's not a chip that automagically fixes all that stuff.