this post was submitted on 02 Nov 2026
30 points (100.0% liked)

homeassistant

21144 readers
11 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 3 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
30
How to monitor 240v ac (US) power use? (lemmy.world)
submitted 4 days ago* (last edited 4 days ago) by AA5B@lemmy.world to c/homeassistant@lemmy.world
15 comments fedilink hide all child comments
 

Can anyone point to resources, reviews or experiences on monitoring power usage in 240v ac (US)?

Looking at the new energy dashboard features …. I have opower integration of my electricity usage and a nice graph. However most of my power usage is from a heat pump, and EV charger, and maybe a garage heater. All are 240v, larger current loads. So the new feature is something about graphing device usage with overall usage. So that would be cool to add

I started searching online and it doesn’t seem especially positive. I see a few clamp meters with integrations but also see reviews that they’re not very accurate.

you are viewing a single comment's thread
view the rest of the comments
[–] dmtalon@infosec.pub 1 points 4 days ago (1 children)

I have two 150a panels in my house and I have 2 emporia vue 2's one on each panel. I reflashed them with esphome so I own the data, it's not going out to emporia. but they work as individual devices collecting data from the clamps.

For non 240 loads you could also use smart plug with power consumption if you're just wanting to track that device. In my use case I am capturing all usage from the two big clamp at the top of each panel then each clamps usage which gives me an 'untracked' value also since I have more than 16 circuits in each panel I cannot track every circuit.

[–] AA5B@lemmy.world 1 points 4 days ago (2 children)

That’s an interesting idea - is there a guide for newbies? I’ve never done anything with esphome.

I had been expecting to use the total power from my utility but perhaps that’s a better idea: measure total power with the same tool as individual.

Right, a big part of the goal is to identify whether untracked is significant.

[–] dmtalon@infosec.pub 2 points 4 days ago

It's been a little while but I did follow a guide for the emporia vue.

There are newer versions and other similar brands out there if I find the guide I used it will be fairly specific to this hardware (certainly the base code setup)

I will look tomorrow