Infuse is not free. I love it and use it on my Apple Devices, but just wanted to have this as an FYI.
WhyAUsername_1
joined 2 years ago
Sub netting baby!
The only llama I care about is this Machu Pichu Llama.
[Reference to Ollama and hating AI slop]
I love thinkpad L480. Also, if you get a good deal then try getting Macbook 2017 Intel version. You could install Linux on that and it's quite light weight.
I agree for the drinks. But I can't cook fries like my local burger place does. And it's cheap, like half a dollar (USD equivalent of my home currency) for 1 box of fries.
Errors to minors;: *Not in sudoers group. This incident will be reported. *
There is also WinGet.
It has always been right beside the printer. Have you never noticed it so far?
Weird, I print PDFs from CD on my phone daily.
Nope. I watch movies /TV Shows with focus. If I need to do something (example attend a phone call), I will pause the movie.
I can't do parallel work while watching.
I never needed transcoding. So jellyfin ran on my Raspi4 for a couple of years. Never faced any issues to be honest. Major issue was hard disk getting disconnected, but then again I had faulty SATA to USB connectors.
9
Suggestion for mounting ServoMotor on the door for Automatic Door Unlock with ESPHome on ESP32
(lemmy.world)
Hello Lemmings, Hope you guys are doing well.
Objective: Open the door automatically through HomeAssistant
My Plan:
-
Use an ESP32 and flash ESPhome. Wire up Servo Motor (SG90) with ESP32. Tie a thread on between the Servo Motor Arm and the physical latch (physical latch that I can pull to unlock the door) such that when the servo motor turns from -100 to +100, the latch is being pulled to cause the door to be unlocked.
-
I am planning to power this using AA Cells + DC DC Boost convertor.
Issue:
- How do I mount the Servo Motor on the door?
- Is there any other (read better) way to achieve the same result?
- Would you recommend any power source other than AA Cells?
Image for reference:
The latch has a keychain-like loop where the thread is tied. To unlock the door manually, I pull the latch towards right (---->) . This action is planned to be automated by Servo Motor.
Hi, I am automating my manual switches at home with ESPHome on NodeMCU. For controlling the switches, I am using 8 channel relay module.
The back of the board has solder-points sticking out. I will be installing this relay module inside the switchboard. So I want to put it in some kind of enclosure.
Just wanted to know your thoughts on enclosure. Should I just wrap the whole thing in electrical tape? Or a plastic box maybe?
Hi everyone, I host a server with few services running for my family and friends. The server freezes sometimes. Where the services stop responding. If I try to ssh into the server, it takes a lot of time (3 to 5 mins) for it to connect. After being connected, every letter I type takes 2 to 3 mins to appear on screen.
Seems like the server is overloaded with tasks. But I am not sure what load it is running. I have netdata installed. I could pull up following screenshots for insights.
Can someone please help me in troubleshooting the issue?
I have tried testing stress testing my RAM and CPU, and they were fine. But I would start troubleshooting from scratch if you have recommendations for testings softwares.
Please also let me know if there is anything I can pull from netdata to help in trouble shooting.
System Specification:
System RAM
Disk I/O
Total CPU Utilization
Idle Jitter
view more: next ›
Not really. The argument is not that everything should be free. I think, I was trying to make a point that Infuse is a third party application that is not free to use (unlike jellyfin).