I did some more searching, and found that nvme to pci-e adapters are affordable. That's going to look a bit janky, but fortunately I don't care.
Thank you again for the suggestion!
Boomkop3
joined 1 year ago
I did not say occasionally. We use AI a lot. Currently it's mostly for image indexing, recognition, object detection, and audio transcription. But we're planning to expand to more, and we'd like to use models that are more accurate
Just some can think of from the top of my head
- not everyone has transport / time
- getting it done earlier means you can't forget or miss later
- safety: some ballot boxes have been set on fire
- it's easier
- shame: some prefer to not show their face to go vote
- safety: a gathering would be a risk with people who have a shitty immune system or asthma
666 upvotes, hahaha
That can't be
googling ..
holy damn you're right
worth a shot then, worst case I return the dock thing
actually I was just looking for that! Thank you!
I've had filament sit for months before it started getting brittle. But it does get very brittle. At least the stuff I have bought so far has
That should be fine, I've printed tens of kilograms pulling the filament around a sharp corner. As long as it's dry, pla can handle quite a bit of abuse. And it's unlikely to damage your printer or dryer.
In the worse case you might have some dust buildup, keep it clean
That is more detail than I went into
Damn, and europe already has a lot of refugees to deal with :p